Site development standards in the R-1:GHC district are as follows:
A.
Minimum lot area for new lots, four thousand five hundred square feet;
B.
Density: six dwelling units per gross acre. Higher densities are possible through density bonuses granted for the provision of affordable housing for households of low or very low income in accordance with the general plan;
C.
Building coverage (maximum): thirty-five percent for all lots excluding porches and decks; however, in no case shall the total building coverage exceed forty-five percent of the total lot;
D.
Maximum impervious surfaces: fifty percent. Impervious surfaces totaling up to sixty percent are permitted for projects providing housing for low or very low income households in accordance with the general plan. Impervious surfaces totaling up to sixty percent may be permitted with review and approval of the city of Angels planning commission subject to site specifics, project needs and environmental constraints;
E.
Maximum building height, thirty-five feet;
F.
Lot width, sixty feet, minimum;
G.
Lot depth, eighty feet, minimum, except for lots with common boundary on golf course or open space, which shall be sixty feet minimum;
H.
Minimum building setbacks:
1.
Front, twenty feet, except lots having side-loaded garages shall be ten feet;
2.
Side:
b.
For lots 116, 117, 118, 119, 120 and 121 of unit one, contiguous with the lot line;
3.
Exterior side of corner lot, ten feet;
4.
Rear:
a.
Principal building with common boundary on golf course or open space, ten feet; all others, twenty feet;
b.
For lots 107 through 114 of unit one, five feet;
c.
Accessory building, five feet;
d.
For properties with a required minimum rear setback of twenty feet, decks and porches shall be allowed to extend from the principal building up to six feet into the rear setback, provided the area of the extension is not wider than twenty feet and the finished floor level of the deck or eave level of the porch is no more than twelve feet in height, as measured from finished grade;
e.
Decks and patios that have a finished floor level of less than thirty inches above finished grade and that do not have railings are permitted in the rear setback;
5.
Between buildings, ten feet;
6.
Vision clearance, thirty-five feet;
I.
Swimming pools shall not be located closer than five feet from any property line or within the front setback;
J.
Fences and walls, except retaining walls, shall not exceed six feet in height, except in the front setback area where the maximum allowed is three feet, and thirty inches in the vision clearance zone;
K.
Retaining walls constructed within building setbacks shall not have exposed surfaces that exceed four feet in height, except:
1.
A series of retaining walls, none of which individually exceed four feet in height, may be used, provided each successive wall is set back or stepped at least one foot for each one foot of height for that wall; and
2.
Within the vision clearance zone, on upsloping lots, a single retaining wall shall be permitted that does not exceed thirty inches in height. Successive or stepped retaining walls shall not be permitted in the vision clearance zone on upsloping lots;
3.
Within side and rear building setbacks that are not adjacent to a street or right-of-way, a retaining wall that faces in toward the subject property may be allowed that is up to eight feet in height;
4.
A retaining wall may be allowed that is up to eight feet in height, provided the wall is being used to retain the existing grade or slope of the site. Cut and fill shall be limited to that which is necessary for construction and upon completion, the location of the top and bottom of the wall shall be substantially similar to the top and toe of the preconstruction slope.
(Ord. 326 (part), 1992. Formerly 17.19.070; Ord. 347 § 1, 1995; Ord. 361 (part), 1998; Ord. 413 § 2, 2004; Ord. 423 § 4, 2005; Ord. 511 § 2 (Att. B), 2021)