The basic intent of these PRD regulations is to replace the usual approval process, involving rigid use and bulk specifications, with more flexible procedures involving a PRD plan submitted by a developer and approved by the Township. These regulations recognize that, while the standard zoning functions (use and bulk) and the standard subdivision functions (platting and design) are appropriate for the regulation of land uses in areas or neighborhoods of the community that are already substantially developed, these controls represent a type of preregulation and regulatory rigidity which would frustrate the application of the PRD concept. Thus, where PRD techniques are permitted, the normal use and dimensional specifications contained elsewhere in this chapter and applicable to the respective residential districts are herein replaced by an approval process in which the approved plan becomes the basis for continuing land use controls. Planned residential development does not necessarily correspond in minimum lot size, type of dwelling unit, density, lot coverage or required open space to any other residential district requirements. The regulations set by this article are minimum regulations within the residential districts and shall apply uniformly to each classification or kind of lot and structure within the respective residential districts. To ensure that the increased flexibility of regulations over land development as authorized herein is carried out under such administrative standards and procedures as shall encourage the disposition of proposals for land development without undue delay, the following review powers are granted to the Planning Commission, which acts as the designated planning agency for the Township:
(1) The Planning Commission shall review all planned residential developments pursuant to the provisions of this chapter and shall make recommendations for approval, approval with conditions, or denial, in writing, to the Board of Supervisors.
(2) The Planning Commission shall ensure that the applicant conforms to all requirements, standards, controls and regulations as are set forth in this chapter.
(3) The Planning Commission and the applicant shall comply with all procedures as set forth in this chapter pertaining to application and hearings on tentative and final approval of a proposed PRD.