Dimensional Requirements
Effective on: 1/1/1901
Buildings which do not conform with the standards set forth by its zoning district or this Article shall follow the standards and regulations for nonconformities set forth in Article 2, Applicability & Conformity.
Effective on: 1/1/1901
The Zoning Administrator may, from time to time, approve administrative modifications from measurable and quantifiable standards of this Ordinance subject to the following limitations:
Effective on: 1/1/1901
When this occurs, the front yard setback shall be the average of the nearby properties.

Effective on: 1/1/1901
The required front, side, and rear yards for individual lots established by the applicable zoning district within which a lot is located shall be measured from the front, side, or rear property line inward toward the center of the lot. Once the required yard areas of a given lot have been established, the remaining area of the lot which is not included in any required front, side, or rear lot shall be known as the buildable area within which the approved structure(s) shall be placed.
![]() |
Effective on: 1/1/1901
Lots that do not conform to traditional orientations require special consideration when determining their setbacks and orientation to the street and adjacent properties.

The front setback shall be measured parallel to the arc of the street right-of-way and follow the same arc that the front lot line forms.
![]() |
On lots having frontage on more than one street, the minimum front yard depth shall be provided on at least one street frontage, with the other frontage(s) having a minimum of one-half the required minimum front yard depth, except that when the lots abut an arterial street, as herein defined, the minimum front yard depth shall be provided each street.
![]()
Multiple Frontage Lot
|
In the case of a triangular or wedge-shaped lot, the required rear setback shall be measured from a line ten feet in length that intersects with both side property lines and is parallel to and at the maximum distance from the front facade of the principal structure.
![]() |
The minimum lot width shall be the lot width measured along the front setback line.
Effective on: 1/1/1901
Yard areas shall be delineated in the following fashion:

Effective on: 1/1/1901
Buildings and structures must be located entirely at or behind setback lines, with the following exceptions.
![]() |
![]() |
Height limitations of this Ordinance shall not apply to such things as church spires, utility towers, solar panels, chimneys, smoke stacks, and necessary mechanical equipment, provided their construction is in accordance with all other City ordinances and is acceptable to the Federal Aviation Agency and the Federal Communication Commission.
Accessory structures less than 120 square feet may be placed within the side or rear setback not less than five feet from a property line and a minimum of ten feet from the principle structure.
Effective on: 1/1/1901
The maximum height shall be established by each zoning district.
![]() |
![]() |
![]() |
Effective on: 1/1/1901