The requirements regarding lot size, building size, and building placement on the lot for each zone district shall be met as indicated in Table 5.1: Zoning District Area Yard and Height Requirements.

5.1.1

General. There shall be a permit fee required for Special Use permits. This fee shall be $250.00 (Two Hundred Fifty Dollars).

Table 5.1: Zoning District Area Yard and Height Requirements

*These distances are distance from the right-of-way.

(Ord. of 8-6-2004; Ord. No. 08-2012, § 2A., 8-27-2012; Ord. No. 2024-02, § 1(Exh. A), 3-25-2024)

Appearance standards shall apply to all single-family detached dwellings including site-built housing, industrialized housing, and manufactured homes. Certificate of Occupancy shall be granted upon the finding that such development shall meet or exceed the Appearance Standards as shown on Table 5.2: Appearance Standards for Single-Family Detached Dwellings.

Notes:

[(1)] 1. The roof shall have a surface of wood shakes, asphalt composition, wood shingles, concrete, fiberglass or metal tiles, slate, built-up gravel materials or other materials approved by the building inspectors.

[(2)] 2. The exterior siding materials shall consist of wood, masonry, concrete, stucco, masonite, metal or vinyl lap or other materials of like appearance.

[(3)] 3. Permanent foundation (including manufactured homes) shall meet the requirements of standard building codes for manufactured homes. The pier foundation shall be 24" × 24" × 16" deep concrete footing. The underpinning for manufactured homes shall be 8" × 8" × 16" masonry block on a foundation 10" wide and 6" deep, unpierced, except for the required ventilation and access, which must be installed so that it encloses the area under the manufactured home to ground level.

[(4)] 4. For manufactured homes, a front landing area is required of at least 100 square feet with a side-to-side dimension of at least 8', on a poured concrete footing, no less than 12" × 12" × 12." All other landings to be a minimum of 5' × 5' on not less than a fabricated masonry footing.

[(5)] 5. Manufactured homes are required to remove all towing devices.

[(6)] 6. Manufactured homes locating in existing, nonconforming manufacturing home parks under type III appearance standards, shall use skirting and vegetation to make towing devices as inconspicuous as possible.

5.3-1 Tabulation of Permitted Uses. Within each zoning district indicated on the Official Zoning Map and subject to all requirements and conditions specified in this Ordinance, land, buildings, and structures shall only be used and buildings and structures shall only be erected which are intended or designed to be used for uses listed in the Permitted Use Schedule, Table 5.3. In the appropriate columns of Table 5.3 uses permitted by right in the various districts are indicated with a "P", uses requiring a Special Use Permit are indicated by an "S", uses permitted by right are subject to meeting additional development standards as set forth in the Zoning Ordinance and Subdivision Regulations.

5.3-2 Formulation of Permitted Use Schedule.

a.

The Standard Industrial Classification Manual - 1987 was utilized in the preparation of this table and shall be referred to as a guide for purposes of interpretation by the Zoning Administrator or Code Enforcement Officer. SIC Codes are used to refer to SIC Classifications. Entries with 0000 in the Reference SIC column do not correspond to any classification in the SIC Manual.

b.

When a use is not listed in the Permitted Use Schedule, the Zoning Administrator or Code Enforcement Officer shall classify it with that use in the table most similar to it. The SIC Manual shall serve as a guide in classifying any unlisted use. If the Zoning Administrator or Code Enforcement Officer should determine that a use is not listed and is not similar to a use in the Permitted Use Schedule, then said use is prohibited.

c.

Rental and leasing of any commodity shall be permitted under the same classification and in the same districts as are sales of that commodity, unless rental or leasing of that commodity is listed separately in the Permitted Use Schedule.

d.

If an industrial plant or facility involves two (2) (or more) manufacturing activities with different SIC codes on the same zone lot, the industrial plant shall be permitted only in those zoning districts where the more restricted activity is permitted. (For example, an industrial plant preparing canned peanuts and also manufacturing the cans is allowed in those zoning districts permitting can manufacturing.)

5.3-3 Mixed Uses. Two (2) or more permitted uses may occupy the same principal building.

5.3-4 Prohibited Uses. Within certain overlay districts, some uses may be prohibited or additional requirements apply, regardless of the uses permitted in the underlying zoning district(s). The following Overlay Districts impose additional requirements to underlying zoning districts:

a.

Historic Neighborhood Overlay District [Article 11].

b.

Highway 29 Overlay District [Article 4].

Table 5.3 Permitted Use Schedule

(Ord. No. 08-2012, § 2B., 8-27-2012; Ord. No. 12-2015; § 1, 12-14-2015; Ord. No. 2022-01, § 1, 2-28-2022; Ord. No. 2024-02, § 1(Exh. A), 3-25-2024; Ord. No. 2024-09, § 1, 9-23-2024)