Must be new as defined by RCW 35.63.160 now or hereafter amended;

Be built to meet or exceed the standards established by federal law in 42 U.S.C. Sections 5401 through 5403, now or hereafter amended;

Must be designated as defined by RCW 35.63.160;

Be set upon a permanent foundation, as specified by the manufacturer, and that the space from the bottom of the home to the ground be enclosed by concrete or an approved concrete product which can be either load bearing or decorative;

Shall comply with all other siting, density, design, and dimensional standards of the zoning district in which they are located; and

Be thermally equivalent to the state energy code.

Route of travel with a traffic control plan;

Time of move; and

Posting of surety bond(s) in an amount adequate to ensure repair to public or private property which may be damaged by movement of the building. The amount of the bond shall be determined by the city public works director.

Garages facing a public street shall be set back a minimum of five feet from the front property line.

Porches, balconies, or similar entry appendages may project into the front yard setback up to three feet from the property line.

Rooflines of new or replacement dwellings shall be a minimum of 3:12 for pitched roofs. Lower pitched roofs or parapet rooflines shall provide additional architectural detailing including but not limited to cornices, caps, relief panels, bay windows, shade projections, rain protection, eaves, dormers, ledges, or overhangs as approved by the planning director.

Rain protection shall be located at the primary entrance which is effectively designed to provide a minimum of 25 square feet of rain protection. This protection may use a single or combination of techniques such as awning, eave, alcove, airlock, or recessed entry.

Finished surfaces on new or replacement dwelling elevations shall emphasize use of architectural-grade natural building products such as wood, masonry, metal, glass, stucco, fiber cement, cultured stone, or other stone materials. Use of plywood, vinyl, plastic composites, fiberglass or similar products shall reflect the surface character of natural building products.

New or replacement structures shall employ a diverse use of color to display individuality within the community. Finished surfaces suitable for painting shall incorporate a color palette of at least two colors, consisting of a base color and an accent (trim color). Repetitive or predictable alternate color schemes are discouraged.

Provide for the ownership and perpetual maintenance of all common areas, including but not limited to:

Promulgate, maintain, and enforce covenants, conditions, and restrictions (CC&Rs) particular to that subdivision or community.

Provide the city clerk's office with notice of HOA activities on an ongoing basis.

Restrict the location of manufactured homes in manufactured home communities that were legally in existence before June 12, 2008, based exclusively on the age or dimensions of the manufactured home;

Prohibit the siting of a manufactured home on an existing lot based solely on its lack of compliance with existing separation and setback requirements; or

Prevent the entry or require the removal of a recreational vehicle used as a primary residence in a manufactured home community. However, a recreational vehicle sited in a manufactured home community will require: