Paxtang City Zoning Code
ARTICLE IV
SR Suburban Residential Zoning District
§ 425-15 Purpose.
This zoning district is generally comprised of those areas of the Borough where suburban-type residential development patterns have been established. These areas generally possess development characteristics such as low-intensity residential uses and building types; larger and wider lots which are accessed from the street, but also including street trees, tree lawns and sidewalks. This zoning district seeks to protect and enhance these areas and neighborhoods by providing general and specific design compatibility standards helping to ensure compatible use, reuse, replacement, infill and redevelopment.
 |  |  |
§ 425-16 Permitted uses.
See Table 3-2 in § 425-14 relating to use tables for uses permitted by right, conditional use and/or special exception in this residential district.[1]
[1]
Editor's Note: The Permitted Uses Tables are attached to this chapter.
§ 425-17 Area and design requirements.
A.
See Table 4-1 in this section relating to area and design requirements for the area and design requirements for all development activities and uses. Additionally, all development activities and uses shall be compatible in character, design, height, scale, setback, orientation, lot access and off-street parking with adjacent and nearby buildings/structures and development on abutting lots as well as lots on the same shared block face (between two intersecting streets) along the same side of the street. Although required in Tables 4-1 and 4-2 in this section relating to area and design requirements and additional development compatibility standards, respectively, referring to certain development compatibility design requirements set forth in Article XI of this chapter relating to the Development Compatibility Standards Overlay Zoning District (DCSO), applicants for new development and uses may, and are strongly encourage, to, utilize the other development compatibility design guidelines and standards set forth in Article XI of this chapter relating to the Development Compatibility Standards Overlay Zoning District (DCSO).
Table 4-1 Area and Design Requirements | |||
|---|---|---|---|
Permitted Uses | |||
Area/Design Features | Single Family Detached Dwelling | Other Permitted Uses (unless specifically listed in Article XVI) | |
Lot area per unit - minimum | 6,000 square feet per DU | 8,000 square feet | N/A |
Minimum lot width at front lot line - interior lot | 60 feet | 80 feet | N/A |
Minimum lot width at front lot line - corner lot | 75 feet | 95 feet | N/A |
Setback - front - minimum/maximum | If abutting lots are developed, see § 425-53F; otherwise, 15 feet minimum/ 25 feet maximum | If abutting lots are developed, see § 425-53F; otherwise, 15 feet minimum/ 25 feet maximum | Not permitted to be located between principal building and public street |
Setback - side minimum | 10 feet each side | 15 feet each side | 5 feet |
Setback - rear minimum | 20 feet | 25 feet | 5 feet |
Impervious lot coverage - maximum | 40% | 65% | Included as part of total maximum impervious coverage |
Vegetative coverage - minimum | 20% | 20% | Included as part of total minimum vegetative coverage |
Building height-minimum/maximum | If abutting lots are developed, see § 425-53G; otherwise, 35 feet maximum | If abutting lots are developed, see § 425-53G; otherwise, 35 feet maximum | 20 feet or not higher than the principal structure, whichever is less. |
 Figure 4.1 Typical Area/Design Features Single-Family Detached Dwelling Example (Abutting Lots Not Developed) (not drawn to scale) |
 Figure 4.2 Typical Building Height Example (Abutting Lots Not Developed) (not drawn to scale) |
B.
Additional development compatibility standards.
(1)
See Table 4-2 of this section relating to additional development compatibility standards and the applicable subsections of Article XI of this chapter relating to the Development Compatibility Standards Overlay Zoning District (DCSO) for additional standards for development activities and uses.
Table 4-2 Additional Development Compatibility Standards | |||
|---|---|---|---|
Development Compatibility Design Standard | Subsection of § 425-53 | Applicability of Development Compatibility Design Standard | |
Front building setback | § 425-53F | Yes | |
Building height | § 425-53G | Yes | |
Building orientation | § 425-53H | Yes | |
Building facade | § 425-53I | Yes | |
Building roof | § 425-53J | Yes | |
Reuse of existing or formerly residential building | § 425-53K | Yes | |
Building footprint | § 425-53L | Yes | |
Fire escape | § 425-53M | Yes | |
Lot access and parking | § 425-53N | Yes | |
Residential garage location and design | § 425-53O | Yes | |
Nonresidential uses within an enclosed building | § 425-53P | Yes | |
§ 425-18 Compliance with general regulations.
Additionally, all development activities and uses within this zoning district shall comply with all applicable general standards of this chapter, including but not limited to:
§ 425-19 Overlay zoning districts.
If located within or affected by the following overlay zoning districts, development activities and uses shall comply with the requirements of the applicable overlay zoning district provisions set forth in Article XI of this chapter relating to overlay zoning districts: