Allenhurst City Zoning Code
§ 26-6.4
Details of Sketch Plat.
[Ord. #6/26/79, § 604]
a.
The submitted sketch plat shall be based on tax map information or some other similarly accurate base and shall be neatly and accurately drawn. The following information shall be included:
1.
The location of that portion which is to be subdivided in relation to the entire tract;
2.
All existing structures and wooded areas within the portion to be subdivided;
3.
The tax map sheet, block and lot numbers;
4.
All proposed lot lines and existing lot lines proposed to be eliminated;
5.
Building setback lines as specified in this chapter;
6.
The approximate location and approximate width of all existing and proposed utility easements in the area to be subdivided;
7.
Zoning district boundaries affecting the tract;
8.
North arrow;
9.
Scale of plat and date of latest revisions;
10.
Area of the entire tract and the area being subdivided to the nearest square foot;
11.
The number of new lots created;
12.
Name and address of owner, subdivider and person preparing plat; and
13.
A key map showing the entire subdivision and its relationship to the surrounding areas at a scale of one (1) inch equals not more than two thousand (2,000') feet.
b.
Special Details and Specifications Required of Proposed Minor Subdivision Prior to Classification. No plat shall be classified by a minor subdivision unless drawn by a professional engineer and/or land surveyor licensed to practice in the State of New Jersey and shall bear the signature, seal and license number and address of the professional engineer and/or land surveyor. The sketch plat shall be based on tax map information or some other similarly accurate base at a scale not more than fifty (50) feet to the inch on one (1) of four (4) standard sizes, namely eight and one-half by thirteen (8 1/2" x 13") inches, fifteen by twenty-one (15" x 21") inches, twenty-four by thirty-six (24" x 36") inches or thirty by forty-two (30" x 42") inches, to enable the entire tract to be shown on one (1) sheet and shall show or include the following information:
1.
Contours as shown on the U.S.G.S. topographic sheets.
2.
Marshes, ponds and land subject to flooding in the subdivision and within one hundred (100) feet thereof.
3.
All areas designated as wetlands under the New Jersey Wetlands Act of 1970 (N.J.S.A. 13:0A-1 et seq.) or so state if there are none. No plat shall be classified as a minor subdivision which contains designated "wetlands" unless accompanied by written approval from the New Jersey Department of Environmental Protection, Bureau of Marine Lands Management.
4.
All areas under the jurisdiction of the Coastal Area Facilities Review Act (N.J.S.A. 13:19-21) shall be shown, or it shall be so stated if there are none.