Background information about the scope of the project, including location, type and size of project;

Site map/construction drawing(s) for the project, including a general location map. At a minimum, the site map should show the total site area; all improvements; areas of disturbance; areas that will not be disturbed; existing vegetation; on-site and adjacent off-site surface water(s); wetlands and drainage patterns that could be affected by the construction activity; existing and final slopes; locations of off-site material, waste, borrow or equipment storage areas; and location(s) of the stormwater discharges(s);

Description of the soil(s) present at the site;

Construction phasing plan describing the intended sequence of construction activities, including clearing and grubbing, excavation and grading, utility and infrastructure installation and any other activity at the site that results in soil disturbance. Consistent with the New York Standards and Specifications for Erosion and Sediment Control (Erosion Control Manual), not more than five acres shall be disturbed at any one time unless pursuant to an approved SWPPP;

Description of the pollution prevention measures that will be used to control litter, construction chemicals and construction debris from becoming a pollutant source in stormwater runoff;

Description of construction and waste materials expected to be stored on-site with updates as appropriate, and a description of controls to reduce pollutants from these materials, including storage practices to minimize exposure of the materials to stormwater, and spill prevention and response;

Temporary and permanent structural and vegetative measures to be used for soil stabilization, runoff control and sediment control for each stage of the project from initial land clearing and grubbing to project close-out;

A site map/construction drawing(s) specifying the location(s), size(s) and length(s) of each erosion and sediment control practice;

Dimensions, material specifications and installation details for all erosion and sediment control practices, including the siting and sizing of any temporary sediment basins;

Temporary practices that will be converted to permanent control measures;

Implementation schedule for staging temporary erosion and sediment control practices, including the timing of initial placement and duration that each practice should remain in place;

Maintenance schedule to ensure continuous and effective operation of the erosion and sediment control practice;

Name(s) of the receiving water(s);

Delineation of SWPPP implementation responsibilities for each part of the site;

Description of structural practices designed to divert flows from exposed soils, store flows, or otherwise limit runoff and the discharge of pollutants from exposed areas of the site to the degree attainable; and

Any existing data that describes the stormwater runoff at the site.

Condition A: stormwater runoff from land development activities discharging a pollutant of concern to either an impaired water identified on the Department's 303(d) list of impaired waters or a total maximum daily load (TMDL) designated watershed for which pollutants in stormwater have been identified as a source of the impairment.

Condition B: stormwater runoff from land development activities disturbing five or more acres.

Condition C: stormwater runoff from land development activity disturbing between one and five acres of land during the course of the project, exclusive of the construction of single-family residences and construction activities at agricultural properties.

All information in Subsection A;

Description of each post-construction stormwater management practice;

Site map/construction drawing(s) showing the specific location(s) and size(s) of each post-construction stormwater management practice;

Hydrologic and hydraulic analysis for all structural components of the stormwater management system for the applicable design storms;

Comparison of post-development stormwater runoff conditions with predevelopment conditions;

Dimensions, material specifications and installation details for each post-construction stormwater management practice;

Maintenance schedule to ensure continuous and effective operation of each post-construction stormwater management practice;

Maintenance easements to ensure access to all stormwater management practices at the site for the purpose of inspection and repair. Easements shall be recorded on the plan and shall remain in effect with transfer of title to the property;

Inspection and maintenance agreement binding on all subsequent landowners served by the on-site stormwater management measures in accordance with Article II of Chapter 209 of this Code.

For Condition A, the SWPPP shall be prepared by a landscape architect, certified professional or professional engineer and must be signed by the professional preparing the plan, who shall certify that the design of all stormwater management practices meet the requirements in this article.