The following regulations apply in the A, RE, RL, R1 and R-2 zones.

This chapter is designed to specify the criteria for the installation of manufactured homes within the city.

Manufactured homes are permitted within specified residential zones that allow a detached one-family dwelling, and under the following criteria:

A.

Manufactured homes must be certified under the National Manufactured Housing Construction and Safety Standards Act of 1974 (42 United States Code, Section 5401 et seq.);

B.

Manufactured homes must be placed on permanent foundations pursuant to a building permit issued by the city and pursuant to Section 18551 of the California Health and Safety Code;

C.

Electrical, gas, water and sewer service to the manufactured home must also be installed under a building permit issued by the city;

D.

Manufactured homes must adhere to the snow load, wind pressure, and building setback requirements of the city;

E.

No manufactured home shall be permitted which exceeds a period of ten years from the date of manufacture to the time of installation; and

F.

Siding material, roofing material and roof overhangs shall be consistent with similar conventionally constructed homes in the vicinity, with roof eave and gable overhangs of not less than one foot, measured from the vertical side of the structure. Exterior covering material shall extend to the top of the concrete or masonry foundation.

(Ord. 373, §15(a), 2023)

A.

All manufactured homes shall undergo design review before obtaining design clearance; design clearance shall be required before the application(s) may be processed for permitting and/or before the proposed activity is commenced. The design review process is established in the design standards.

B.

Manufactured homes shall not be permitted within areas designated as "historic" or "historic corridor" on the general plan land use maps, or in areas which carry the HR (historic residential) combining zone designation as shown on the zoning map.

(Ord. 373, §15(b), 2023)