¹ No commercial or manufacturing structure shall be located closer than one hundred (100) feet to a residential zone district boundary line.

² The front yard setback area of Commercial or Manufacturing districts shall be maintained in a vegetated condition; where Commercial or Manufacturing property abuts a residential zone district boundary, the side and rear yard setback area abutting said residential boundary shall also be maintained in a vegetated condition.

³ The subdivision of any land within the R-1 zoning district after the adoption of this ordinance shall also require a minimum density of at least sixty thousand (60,000) square feet per building lot.

⁴ The maximum percent of the lot area which may be covered by buildings and impervious surfaces.

⁵ The dimensional regulations of the RFR-80 district shall apply to the Residential Special district (RS), the Neighborhood Business district shall apply to the Neighborhood Business Special district (NBS), the Commercial district to the Commercial Special district (CS), and the Manufacturing district to the Manufacturing Special district (MS).

⁶ For two-family and multifamily dwellings, the minimum lot size shall be determined by multiplying the number of units by eighty thousand (80,000) square feet.

⁷ Electric substation in manufacturing zones shall require front, side and rear yard setbacks to be two hundred (200) feet from any residential use. The maximum percentage coverage of the lot that may be covered by buildings, transformers, fencing and impervious surfaces shall not exceed twelve (12) percent and the minimum lot size shall be twelve (12) acres.

(Ch. 134, § 6, 12-19-94; Ch. 210, § 2, 7-20-09)