OBSOLETE DISTRICTS DEVELOPMENT STANDARDS
TABLE 5-I REQUIRED BUILDING SETBACK FOR NEW DEVELOPMENT
(BY ZONING DISTRICT)
*Rear setbacks shall be for principal buildings only.
*All distances are in feet and are measured from their respective property line.
*Residential setbacks in existing subdivisions shall be those in place at the time of plat approval.
*Commercial uses in the Mixed Residential District may use setbacks stated for the Commercial Center District.
*Landscape setbacks adjacent to public streets shall be provided in compliance with Article 5, Development and design Standards and Guidelines. If the required building setback in this table is less than the required landscape setback, the building may encroach into the landscape setback; however, no paved surfaces for parking or storage are permitted within the required landscape setback.
*Landscape buffers separating dissimilar land uses shall be provided in compliance with Article 5, Development and Design Standards and Guidelines. If the required buffer exceeds the required building setback, the required buffer distance shall override the setback and act as the minimum building setback from the applicable property line.
TABLE 5-J RESTRICTIONS ON BUILDING HEIGHT
FOR NEW DEVELOPMENT (BY ZONING DISTRICT)
TABLE 5-K RESTRICTIONS ON LOT WIDTH AND COVERAGE
FOR NEW DEVELOPMENT (BY ZONING DISTRICT)
*All dimensions are in feet
*The lot width requirements do not apply to existing lots
TABLE 5-L REQUIRED MINIMUM LOT AREA
(BY ZONING DISTRICT)
*Lot area is the amount of land contained within a lot, measured in acres or in square feet.
*Existing lots are exempted from lot area requirements listed above.
*Mixed use projects in the CC District may utilize the full parcel area in calculating permitted dwelling units, which may allow for higher density on portions of a master site planned area.
(Ord. No. 28-25, § 3, 10-21-2025)
OBSOLETE DISTRICTS DEVELOPMENT STANDARDS
TABLE 5-I REQUIRED BUILDING SETBACK FOR NEW DEVELOPMENT
(BY ZONING DISTRICT)
*Rear setbacks shall be for principal buildings only.
*All distances are in feet and are measured from their respective property line.
*Residential setbacks in existing subdivisions shall be those in place at the time of plat approval.
*Commercial uses in the Mixed Residential District may use setbacks stated for the Commercial Center District.
*Landscape setbacks adjacent to public streets shall be provided in compliance with Article 5, Development and design Standards and Guidelines. If the required building setback in this table is less than the required landscape setback, the building may encroach into the landscape setback; however, no paved surfaces for parking or storage are permitted within the required landscape setback.
*Landscape buffers separating dissimilar land uses shall be provided in compliance with Article 5, Development and Design Standards and Guidelines. If the required buffer exceeds the required building setback, the required buffer distance shall override the setback and act as the minimum building setback from the applicable property line.
TABLE 5-J RESTRICTIONS ON BUILDING HEIGHT
FOR NEW DEVELOPMENT (BY ZONING DISTRICT)
TABLE 5-K RESTRICTIONS ON LOT WIDTH AND COVERAGE
FOR NEW DEVELOPMENT (BY ZONING DISTRICT)
*All dimensions are in feet
*The lot width requirements do not apply to existing lots
TABLE 5-L REQUIRED MINIMUM LOT AREA
(BY ZONING DISTRICT)
*Lot area is the amount of land contained within a lot, measured in acres or in square feet.
*Existing lots are exempted from lot area requirements listed above.
*Mixed use projects in the CC District may utilize the full parcel area in calculating permitted dwelling units, which may allow for higher density on portions of a master site planned area.
(Ord. No. 28-25, § 3, 10-21-2025)