Every building hereafter constructed upon a building site shall be located on the site so as to provide for the yards specified in the regulations for the district in which the site is located.
(a)
Every front or rear yard shall extend along a lot line the full width of the lot and every side yard shall extend along a lot line from the front yard or the front lot line to the rear yard. A required yard shall be open and unobstructed from the ground upwards, except as otherwise provided herein. The required minimum depth or width of any yard shall be measured generally at right angles to the lot line and from the nearest point of the building. Where the side lot lines converge to a point, a line five (5) feet long within the lot parallel to and at a maximum distance from the front lot line shall be deemed to be the rear lot line for the purpose of determining the depth of the rear yard.
(b)
Where the building wall is not parallel to a side or rear lot line, the building’s average setback shall be used to determine compliance with minimum building setback requirements. The building shall have a minimum three (3) foot side yard setback at any point and a minimum ten (10) foot rear yard setback at any point.
(c)
The required front yard setback or side yard setback on the street side of a corner lot shall be measured from the face of curb of the adjacent public right-of-way.
(d)
Paving in the front yard shall be limited to a maximum of fifty percent (50%) of the front yard area. Greater than fifty percent (50%) may be allowed in circumstances where the driveway is the same width as that of the garage frontage. The planning manager may grant minor exceptions when in substantial conformance with the intent of this section.
(Ord. No. 2013-08, § 2 (Exh. A), 8-5-2013)