The purpose of the Woodside overlay district is to establish a set of regulations that are consistent with the established development pattern of the Woodside Acres subdivision. The intent of the regulations in this overlay district is to encourage continued investment in the well-established subdivision, where the platted lots are smaller in size and setbacks that the township's other single-family residential districts. The overlay district is intended to regulate dimensional and placement standards only, while retaining the same permitted uses of the underlying zoning district.

(Ord. No. 02-21, § 1, 2-1-2021)

The Woodside overlay district is a mapped zoning district that imposes a set of requirements in addition to those of the underlying zoning district. In an area where an overlay district is established, the property is placed simultaneously in the two districts, and the property may be developed only under the applicable conditions and requirements of both districts. In the event there is a conflict between the requirements of the two districts, the requirements of the Woodside overlay district shall prevail.

(Ord. No. 02-21, § 1, 2-1-2021)

The Woodside protection overlay district boundaries shall be established on the official township zoning map. The overlay district boundaries may be amended according to the zoning ordinance procedures in article 9.00.

(Ord. No. 02-21, § 1, 2-1-2021)

Buildings and uses in the Woodside overlay district shall be subject to the following standards:

A.

Minimum lot size: 9,800 square feet.

B.

Minimum lot width: 70 feet.

C.

Side yard setback: Ten feet.

D.

Corner lots in this district shall have one front yard. The front yard shall be the platted front lot line, typically the narrow frontage of the established platted lots.

(Ord. No. 02-21, § 1, 2-1-2021)