Note, the second number, in parenthesis, is the width/set-back requirement when using methods two or three for subdivision development.

• Note #1 - (Applies throughout) For use of a lot for group dwellings, multiple family dwelling, or other conditional uses as specified in this ordinance, the lot area and width of the particular property would have to be approved by the proper municipal authorities before such uses could be allowed.
• Note #2 - As Determined by the City Council following a review by the Planning Commission.
• Note #3 - Ten feet minimum side/rear setback is required where the side or rear yard abuts an agricultural or residential zone, or where the yard abuts a current residential use.  Twenty feet minimum is required where the side yard is adjacent to a street.  Any applicable modifying regulations may also require side setbacks.  No minimum side/rear setback is required when abutting other commercial zones.   An exception may be granted by the City Council to allow for not less than a ten-feet (10’) side yard where said side yard is adjacent to a street if it can be shown that at least one hundred (100) feet of minimum sight distance will be maintained past any structure(s) on the property and between intersecting right-of-way lines (or a line twenty-five feet (25’) from the center line in the case of an intersecting private driveway or alley) for any intersecting roadways, streets, alleys, or driveways. 
• Note #4 - Minimum set backs, lot width and size of lots in this zone are to conform to the adjacent zone. If the property has more than one adjacent zone the Planning and Zoning Commission will determine the applicable area, width, and yard regulations based on the lot’s adjacent zones.
• Note #5 - None, except that for any parcel in the MC zone having a lot line in common with a lot in an adjoining zone or lying across the street or alley from such adjoining zone, the side and rear yards prescribed for such adjoining zone shall be maintained in the MC zone.
• Note #6 - The minimum lot size; lot width; front, rear and side yard requirements for the M-2 Zone accepted and approved by the city are the same standards as set forth in the “Declaration of Covenants, Conditions and Restrictions of the Utah State University Research and Technology Park” as filed with the Cache County Recorder 26 October, 1987.
• Note #7 - All buildings shall maintain a minimum side and rear setback of forty feet from other properties. For each foot by which the main hospital building exceeds thirty-five feet in height, the requirement for side yards shall be increased by one additional foot on each side of the building.
• Note #8 – Other than single-family residence, setbacks, lot sizes including lot widths for uses designated by “M” in the zoning matrix for both Mixed Use Zones are established by the Mixed Use Development Plan as reviewed by the Planning Commission and approved of the City Council (See Sections 12C-1050 through 12C-1057.) 
  
• Note #9 - Any parcel with frontage on Main Street shall have a minimum front setback of twenty five (25) feet measured from the back of curb. All other parcels have a minimum front setback of ten (10) feet measured from the back of curb of the designed future right of way.
• Note #10 - Any lots created within a Geologic Hazard Area with primarily northern or southern facing street frontage, and lot widths running primarily east to west, shall have a minimum lot width of not less than 130 feet. The building envelope of these lots shall allow for a side yard setback of not less than 25 feet on each side yard. Lots with this configuration that also have a side yard adjacent to a street shall have a minimum side yard setback of 25 feet on the non-street-adjacent side yard, and a minimum street-adjacent side yard setback of 30 feet.