The building site (B) district is intended to be combined with any principal district to modify the minimum building site standard otherwise applicable in the principal district.

(Ord. 97-99 § 1 (part))

Uses permitted in the B district are all uses permitted in the principal district with which the B district is combined, provided the administrative and use permit requirements of the principal district shall apply.

(Ord. 97-99 § 1 (part))

A.

The following minimum building site standards shall apply to all principal districts with which the following districts are combined:

1.

B: The minimum building site expressed in thousands of square feet, as indicated by a number following the hyphen (e.g., B-8 means eight thousand (8,000) square foot minimum building site);

2.

BA: The minimum building site expressed in acres, as indicated by a number following the hyphen (e.g., BA-5 means five acre minimum building site);

3.

BSM: The minimum building site is the area of the individual lot, as shown on a recorded parcel or final map. If no map has been recorded, the lot that was to be divided shall be subject to the regulations of the principal district, but only to the extent that the regulations do not conflict with the approved tentative map or its conditions of approval, until the map approval expires or is relinquished by the property owner. Intended to be applied only where no further land divisions are expected.

B.

The following building site limitations shall apply to all principal districts with which the following districts are combined:

1.

BL: The number of building sites existing and allowed to be created is limited to a maximum of the number following the hyphen (e.g., BL-3 means a maximum of three building sites are allowed). This is intended to be applied to lots that qualify for more than one building site, based on allowed general plan densities, but are limited in the number of building sites allowed because a portion of the residential density applicable to the lot has been utilized to create other lots in the vicinity (density averaging). The minimum building site shall be determined by the principal district;

2.

BP: Further division of the lot cannot occur until the access road is constructed to city development standards, including paving.

C.

All other site development standards of the principal district must be met in order to qualify for the minimum building site or number of buildings allowed by the B district.

(Ord. 97-99 § 1 (part))