The Preliminary Plat shall show the following:

1. GENERAL. The Preliminary Plat shall be prepared by a licensed land surveyor at an engineers' scale not more than one inch (1") equals one hundred feet (100'), may be prepared in pen, or pen and pencil, and the sheets shall be numbered in sequence if more than one (1) sheet is used and shall be of such size as is acceptable for filing in the office of the County Recorder, but shall not be larger than twenty-four inches by twenty-six inches (24" x 26"). It should be noted that the map prepared for the Preliminary Plat may also be used during the preparation of the final Subdivision Plat and, therefore, should be drawn on tracing cloth or reproducible mylar. 
   
2. NAME.
   
   1. Name of Subdivision if Property is within an existing Subdivision.
      
   2. Proposed name if not within a previously platted Subdivision. The proposed name shall not duplicate the name of any plat previously recorded in Summit County, Utah.
      
   3. Name of Property if no Subdivision name has been chosen. This is commonly the name by which the Property is locally known.
      
   4. Name, address, including telephone number, or the professional Person(s) responsible for Subdivision design, for the design of public improvements, and for surveys.
      
   5. Names of new Streets, subject to the approval by the Planning Commission.
      
3. OWNERSHIP. Name and address, including telephone number, of legal Owner or Agent of Property, a Property report, and citation of last instrument conveying title to each Parcel of Property involved in the proposed Subdivision, giving grantor, grantee, date, and land records reference.
   
   1. Citation of any existing legal Rights-of-Way or easements affecting the Property.
      
   2. Existing covenants on the Property, if any.
      
   3. Name and address, including telephone number, of the professional Person(s) responsible for Subdivision design, for the design of public improvements, and for surveys. 
      
4. DESCRIPTION. Location of Property by government Lot, section, township, range and county, graphic scale, north arrow, and acres. 
   
   1. Location of Property Lines; existing easements; burial grounds; Physical Mine Hazards; known geologic hazards; railroad Rights-of-Way; water courses; Wetlands; wooded Areas or trees six inches (6") or more in diameter, measured four feet (4') above ground level; groves of five (5) or more smaller trees, or clumps of oak or maple covering an Area of fifty square feet (50 sq. ft.) to the drip line; location, width, and names of all existing or platted Streets or other public ways within or immediately adjacent to the tract; and names of adjoining Property Owners from the latest assessment rolls within three hundred feet (300') of any perimeter boundary of the Subdivision.
      
   2. Location, sizes, elevations, and Slopes of existing sewers, water mains, culverts, and other underground Structures within the tract and immediately adjacent thereto; existing permanent Building and utility poles on or immediately adjacent to the Site and utility Rights-of-Way.
      
   3. Approximate topography, at the same scale as the Preliminary Plat with at least five foot (5') contour intervals.
      
   4. The approximate location and widths of proposed Streets.
      
   5. Preliminary proposals for connection with existing municipal water supply and District sanitary sewer systems; and preliminary provisions for collecting and discharging surface water drainage.
      
   6. The approximate location, dimensions, and Areas of all proposed and/or existing Lots.
      
   7. The approximate location, dimensions, and Areas of all Parcels of land proposed to be set aside for park or playground Use or other public Use, or for the use of Property Owners in the proposed Subdivision.
      
   8. The location of temporary stakes to enable the Planning Commission to find and appraise features of the Preliminary Plat in the field.
      
   9. Whenever the Preliminary Plat covers only a part of an Applicant's contiguous holdings, the Applicant shall submit, at the scale of no more than two hundred feet (200') to the inch, a sketch in pen or pencil of the proposed Subdivision Area, together with its proposed Street and trail system, and an indication of the probable future Street and drainage system of the remaining portion of the tract.
      
   10. A vicinity map showing Streets and other general Development of the surrounding Area. The Preliminary Plat shall show all school and improvement district lines with the zones properly designated.
       
   11. A plan designating Limits of Disturbance for each Parcel and for Subdivision improvements, such as utilities and roads.
       
5. FEATURES. 
   
   1. The location of Property with respect to surrounding Property and Streets, the names of all adjoining Property Owners of record or the names of adjoining Developments, the names of adjoining Streets.
      
   2. Citation of any existing legal Rights-of-Way or easements affect the Property.
      
   3. Existing covenants on the Property, if any.
      
   4. The location and dimensions of all boundary lines of the Property to be expressed in feet and decimals of a foot.
      
   5. The location of existing Streets, easements, water bodies, streams, and other pertinent features such as swamps, railroads, Buildings, parks, cemeteries, drainage ditches, Physical Mine Hazards, or bridges.
      
   6. The location and width of all existing and proposed Streets and easements, alleys, trails, and other public ways, and easement and proposed Street Rights-of-Ways and Building Setback lines.
      
   7. The location, dimensions, and Areas of all proposed or existing Lots.
      
   8. The location and dimensions of all Property proposed to be set aside for park or playground Use, or other public or private reservation, with designation of the purpose thereof, and conditions, if any, of the dedication or reservation.
      
   9. The name and address of the Owner or Owners of land to be subdivided, the name and address of the Applicant and/or Developer if other than the Owner, and the name of the land surveyor.
      
   10. The date of the map, approximate true north point, scale, and title of the Subdivision.
       
   11. Sufficient data acceptable to the City Engineer to determine readily the location, bearing, and length of all lines, and to reproduce such lines upon the ground.
       
   12. Indication of the Use of any Lot, single family, two-family, multi-family, townhouse, and all use other than residential proposed by the Applicant.
       
   13. All Lots in each block shall be consecutively numbered. Outlots shall be lettered in alphabetical order.
       
   14. The following notation shall also be shown:
       
       1. Explanation of drainage easements, if any.
          
       2. Explanation of Site easements, if any.
          
       3. Explanation of reservations, if any. 
          
       4. Owners dedication, if any and consent to record as required by State law.
          
   15. Any restrictions or requirements necessary to ensure solar Access shall be defined.
       
   16. All utility facilities existing and proposed throughout the Subdivision shall be shown on the Preliminary Plat or on accompanying engineering plans.
       
   17. A plan designating Limits of Disturbance or Building Pads and utilities corridors and connections for each Parcel and for Subdivision improvements, such as utilities and roads.

1. GENERAL. Construction Plans shall be prepared for all required improvements. Plans shall be drawn at a scale of no more than inch equals fifty feet (50'), and map sheets shall be of the same size as the Preliminary Plat. The following shall be shown:
   
   1. Profiles showing existing and proposed elevations along left and right edge of road, and center lines of all roads. Where a proposed road intersects an existing road or roads, the elevation along the center line of the existing road or roads within one hundred feet (100') of the intersection shall be shown. Approximate radii of all curves, lengths of tangents, and central angles on all Streets.
      
   2. The Planning Commission may require, upon recommendation by the City Engineer, where Steep Slopes exist, that typical cross-sections of all proposed Streets be shown.
      
   3. Plans and profiles showing the locations and typical sidewalks, drainage easements, irrigation ditches, servitudes, Rights-of-Way, manholes, and catch basins; the locations of Street trees, Street lights, and Street signs; the location, size, and invert elevations of existing and proposed sanitary sewers, storm water drains, and fire hydrants, showing connections to any existing or proposed utility systems; and exact location and size of all water, gas, or other underground utilities or Structures.
      
   4. Location, size, elevation, and other appropriate description of any existing facilities or utilities, including, but not limited to, existing Streets, sewers, drains, water mains, easements, water bodies or impoundments, streams, and other pertinent features such as swamps, railroads, Buildings, features noted on the Official Zoning Map or Master Plans, at the point of connection to proposed facilities and utilities within the Subdivision, and each tree with a diameter of six inches (6") or more, measured four  feet (4') above ground level; groves of five (5) or more smaller trees, or clumps of oak or maple covering an Area of fifty square feet (50 sq. ft.) to the drip line. The water elevations of adjoining lakes or streams at the date of the survey, and the approximate high- and low-water elevations of such lakes or streams. All elevations shall be referred to the Park City Engineer's or U.S.G.S. datum plane. If the Subdivision borders a lake, river, or stream, the distances and bearings of a meander line established not less than twenty feet (20') back from the ordinary high-water mark of such water ways.
      
   5. Topography at the same scale as the Preliminary Plat with a contour interval of two feet (2'), referred to sea-level datum. All datum provided shall be latest applicable U.S. Coast and Geodetic Survey datum and should be so noted on the plat.
      
   6. All other specifications, details, and references required by the Park City Design Standards, Construction Specifications, and Standard Drawings, including a Site-Grading plan for the entire Subdivision.
      
   7. Notation of approval of the Preliminary Plat as follows:
      
      ____________________________________
      Owner                                             Date
      
      ____________________________________
      City Attorney                                 Date
      
      ____________________________________
      City Engineer                                 Date
      
      
   8. Title, name, address, signature, and seal of professional engineer, and date, including revision dates.
      
   9. A Limits of Disturbance and revegetation plan.

1. GENERAL. The final Subdivision Plat shall be presented in India ink on tracing cloth or reproducible mylar at the same scale and contain the same information, except for any changes or additions required by the Planning Commission, as required by Section 15-7.4-1 Preliminary Plat. The Preliminary Plat may be used as the final Subdivision Plat if it meets these requirements and is revised in accordance with the Planning Commission's requirements. All revision dates must be shown as well as the following: 
   
   1. Notation of any self-imposed restrictions, and locations of any Building lines proposed to be established in this manner, if required by the Planning Commission in accordance with these regulations. 
      
   2. All monuments erected, corners, and other points established in the field in their proper places. The material of which the monuments, corners, or other points are made shall be noted at the representation thereof or by legend. The legend for metal monuments shall indicate the kind of metal, the diameter, length, and weight per lineal foot of the monuments.
      
   3. Form for endorsements by the Planning Commission chair, City Recorder, City Engineer, City Attorney, Snyderville Basin Water Reclamation District and other entities as required by the City Engineer. 
      
2. PREPARATION. The final Subdivision Plat shall be prepared by a land surveyor licensed by the State of Utah.  The surveyor shall certify that the survey of the Property described on the Plat is in accordance with Title 17, Chapter 23, Section 17 of the Utah Code as amended, and has verified all measurements and has placed monuments as represented on the Plat.